8
| Kaden Owner’s Manual
3. Care and Maintenance
Safety Precautions
Unit Maintenance
Before Cleaning
or Maintenance
• Always turn off your air conditioning system and
disconnect its power supply before cleaning or
maintenance.
•
Do not
use chemicals or chemically treated cloths to
clean the unit.
•
Do not
use benzene, paint thinner, polishing powder
or other solvents to clean the unit. They can cause the
plastic surface to crack or deform.
•
Do not
wash the unit under running water. Doing so
causes electrical danger.
•
Do not
use water hotter than 40°C to clean the
front panel. This can cause the panel to deform or
become discolored.
• Clean the unit using a damp, lint-free cloth and neutral
detergent. Dry the unit with a dry, lint-free cloth.
• Contact an authorised service technician for repair or
maintenance of this unit. Improper repair and maintenance
may cause water leakage, electrical shock, or fire, and may
void your warranty.
•
Do not
substitute a blown fuse with a higher or lower
amperage rating fuse, as this may cause circuit damage
or an electrical fire.
• Please make sure the drain hose is set up according to the
instructions. Failure to do so could cause leakage and result
in personal property damage, fire and electric shock.
• Make sure that all wires are connected properly. Failure to
connect wires according to instructions can result in electrical
shock or fire.
Repairing Refrigerant Leaks
WARNING
• If the refrigerant leaks, turn off the air conditioner and
any combustible heating devices, ventilate the room and
call your dealer immediately. Refrigerant is both toxic
and flammable.
Do not
use the air conditioner until the
leak is repaired.
• When the air conditioner is installed in a small room,
measures must be taken to prevent the refrigerant
concentration from exceeding the safety limit in the
event of refrigerant leakage. Concentrated refrigerant
causes a severe health and safety threat.
Preparation for Periods
of Non-Use
Maintenance after Extended
Non-Use
1. Remove any obstacles blocking the vents of both the
indoor and outdoor units.
2. Turn on the main power switch at least 12 hours prior to
operating the unit.
Storing the Unit While Not in Use
1. Run the appliance on
FAN
mode for 12 hours in a
warm room to dry it and prevent mold.
2. Turn off the appliance.
