11/37
11
13. Lock keypad commands
Using keypad commands, a user can do maintenance operations on the lock.
The following table lists the modes and available commands.
Mode
Commands
Factory
Only one command is available in factory mode:
Set construction mode pin
Construction
All commands, without any restriction, are available in factory mode:
Set construction pin (in factory or construction mode)
Configure lock using an admin card
Set
date
Set
time
Set temporary passage mode duration
Activate/deactivate passage mode
Activate/deactivate
lockout
Perform
diagnostics
Identify the lock model
Start a maintenance unit communication session
Access
All commands with the exception of ‘Set construction pin’ are available IF the related
privileges are granted (see table below).
The following table lists the privileges required to access keypad commands. These privileges are REQUIRED
once the lock is configured (using an admin card).
Important:
The privileges must be assigned on the headend
system and stored on user cards.
Privilege
Command
Keypad programming
Set
date
Set
time
Perform
diagnostics
Identify the lock model
Lockout
Activate/deactivate
lockout
Maintenance unit
programming
Start a maintenance unit communication session
Passage mode
Set temporary passage mode duration
Activate/deactivate passage mode
Admin card configuration
Configure lock using an admin card
13.1 Entering keypad programming mode
Keypad programming mode is entered differently, depending on the current operation mode. Start the keypad
programming mode by pressing the # key followed by PIN #, if the lock is in construction mode, for example. The
