20/37
20
16. Quick lock configuration
The following tables describe the sequence of commands required to configure the lock from factory,
construction and access mode. Note that:
o
Typically a timeout of 5 seconds applies to key presses and card detection. After this delay, the
current operation is cancelled (red led turns on along with low pitch sound).
o
Keypad commands are always followed by a ‘#’ key.
16.1 In Factory or Construction mode
Step
Sub
Description/Operation
Notes
1
Reset the lock to factory mode
1
Insert and turn mechanical key in key
cylinder to retract latch and hold
Note: Resetting the lock to factory defaults
can be done while in any mode -> factory,
construction or access.
2
Press and release ‘#’ key on lock keypad
3
Release mechanical key
Once done, red and green led leds blink in
alternate sequence
4
Enter reset command:
o
12345678#
Once done, green led blinks with high pitch
sound indicating successful operation
2
Enter lock keypad programming.
Programming mode is entered by pressing
the ‘#’ key followed by the default PIN and
then pressing ‘#’ again. Any command will
exit back to keypad programming mode if
the lock is idle for 5 seconds. The keypad
programming mode is itself exited when no
key is pressed for 5 seconds.
1
Enter keypad programming mode by
typing:
o
#12345678#
Green led and high pitch sound on success.
3
Change default (factory mode) PIN
Must change default pin to enter
construction mode.
1
Enter the change PIN command:
o
000#
2
Enter the new (construction mode) PIN:
o
XXXXXXXX#
The construction PIN is always 8 digits.
3
Enter the new PIN AGAIN:
o
XXXXXXXX#
Once entered, the green led turns on with a
high pitch on success.
4
Prepare the maintenance unit (M-Unit)
1
Start the E-Plex 5900 M-Unit application
on the PDA
2
Select ‘Comm key’ option
3
Enter the communication key (16 zeros
by default) and select ‘ok’
Upon factory reset, the communication key
is set to 16 zeros.
4
Select the ‘Set Time’ option and set the
date/time related parameters.
Important:
It is extremely important that the
date/time be set correctly. The date, time
and time zone must be set properly because
the card-connected credentials rely on them.
Once in access mode, invalid time settings
