1
I
NTRODUCTION
The X-09 uses sophisticated computer security and makes dialing much easier than that of
traditional combination locks. The microprocessor in the lock recognizes a number as part
of a combination when you change dialing direction. (See the section on Dialing the X-09.)
Note:
The lock is shipped preset to operate in the Single Combination Mode with
a
Default Factory Combination
of 50-25-50.
LOCK ON BACK COVER
The Lock On Back Cover (LOBC) feature provides a locking mechanism that locks the back
cover in place after installation. The design is such that the back cover cannot be removed
without visible damage unless the combination is known, regardless of whether the lock is
locked or unlocked.
Note:
The 6-digit lock serial number is located in 2 places on the lock.
The first location is in the form of a removable sticker on the back
cover (see Figure 1), which is designed for the security professional
in charge of this lock to peel off and place on the proper form. The
second location is on the electronics card, next to the super-capacitor,
in the form of a permanent label also showing a barcode (see Figure 2).
Since you may need the serial number of the lock to reset it if the
combination is lost or forgotten and the door is open, it is important
that you keep a record of the lock serial number in a secure place.
Because of the LOBC feature, it is not an easy task to remove the back
cover to read the lock serial number after the
lock is installed. If you do not have the serial
number from the removable label, follow the
procedure below to remove the back cover
and retrieve the serial number.
To Remove the Lock on Back Cover:
1. Dial the combination(s) to open the lock and then
retract the bolt.
2. Release the container locking bolts.
3. Open the container.
4. Remove the dust cover plate.
5. Locate the lock on back cover pin on the back
cover of the lock case. (See Figure 1)
6. Turn the dial to the
left
to extend the bolt. Do not
close the container.
7. Dial the combination(s) to open the lock.
8. Before turning the dial to retract the bolt, pull out
on the unlocking button.
9. While holding the button out, turn the dial to the
right
to retract the bolt to the unlocked position.
10. Remove the back cover screws.
11. Remove the back cover assembly.
12. Look at the label next to the round super-capacitor on the system card to get the lock
serial number. (See Figure 2)
Figure 2 - Serial # on label
next to capacitor
Figure 1 - Lock On Back Cover
Lock On Back
Cover Pin
Serial Number
Sticker
