2
D
IALING
THE
X-09
DIALING METHODS
The user should dial with complete, full wrist turns. Stopping to re-grip produces pauses in
dialing activity. This helps the X-09 distinguish between human and robotic dialers.
Note:
The viewing angle of the LCD is restricted from either side as a security
feature of the lock. This feature restricts viewing of combination dialing by the casual
observer. The display may also appear slightly more dim than previous versions of
the X-xx lock.
TO POWER THE LOCK
You should dial to the left (Counter-clockwise) to “power” the lock unless otherwise
instructed for a specifi c operation. It usually requires 5-10 turns of the dial to generate
suffi cient power for lock operations.
The lock is considered to be “powered” as soon as
something (number, letter, symbol) appears on the display.
Note:
While the lock is powered, you will notice that the intensity level of the LCD
will vary. The display may appear to become brighter or more dim at different points
in operation. The variations in the display occur due to a security feature of the lock
and should not be of concern to the user.
When you dial to power the lock, it will fi rst display any error conditions that exist on the lock.
If you continue to dial left and if the number of consecutive unsuccessful attempts is three
or more, the unsuccessful attempts count will be displayed along with a lightning bolt. You
must slow down or stop dialing to pause and view the count. The count will disappear when
you dial left to resume operations or when the lock powers down.
DIALING A COMBINATION
The X-09 recognizes a number as being part of a combination when you stop dialing on
that number and then reverse dialing directions. When dialing a combination, you will
dial
left for the 1st two digits of the combination
,
dial right for the second two digits
, and
then
dial left again for the last two digits
. When dialing to the left, the numbers will be
displayed in an increasing fashion as you dial. When dialing to the right, the numbers will be
displayed in a decreasing fashion.
Note:
If at any time the dial remains stationary for more than 40 seconds, the
lock will power down (LCD will go blank), requiring the operator to redial the entire
combination.
Once the combination has been dialed correctly, you must dial briskly to the right to get an
OP
(
OP
en right) display and to retract the bolt.
Note:
If an incorrect combination is dialed or if the elapsed dialing time of the
combination is less than 10 seconds, a lightning bolt will appear when you dial
right to retract the bolt.
