13
2
!
If the screw hits a nail
under the shingle, there are
a few solutions. Leave the
nail and use the rest of the
holes if possible, if not:
1. Remove the nail
2. Angle the driver to avoid
the nail
3. Use a 3mm steel drill to
make a hole.
Modified Deck
Part D: Ensuring Proper Installation
1
!
Proper torque will vary based on the characterisitcs of the rafter and deck. It's best practice to tighten the wood
screws until the washer stops rotating. After completing process, make sure the Splice Foot X/XL is securely fixed.
You may verify that the screws underneath the deck panel are stained with butyl rubber. This indicates a good
flashing performance. Butyl should extrude from the sides of the mount.
Summary of Contents for 4000113
Page 22: ...22 Notes ...
Page 23: ...23 Notes ...
