PELLET BURNING STOVES INSTALLATION & MAINTENANCE MANUAL
30
If the stove cools down below a minimum temperature, then the stove will switch off. This switch off can also occur if
pre-heating is too slow.
5. MAINTENANCE AND CLEANING
ATTENTION!
All cleaning of all parts must be carried out with the stove completely cold and unplugged.
The stove does not need much maintenance if used with certified quality pellets.
5.1. DAILY OR WEEKLY CLEANING PERFORMED BYTHE USER
5.1.1. BEFORE EACH IGNITION
Clean the ash "
F
" and any deposits in the brazier that could clog the air
passage holes.
In case of pellets running out in the tank or of a failed ignition alarm (E2),
there could be unbent pellets in the brazier. Always empty the residue in the
brazier before each ignition.
REMEMBER THAT ONLY A CORRECTLY POSITIONED AND
CLEAN BRAZIER CAN GUARANTEE IGNITION AND OPTIMAL
OPERATION OF YOUR PELLET PRODUCT.
IF IGNITION FAILS (E2), IT IS IMPORTANT TO REMOVE THE PELLETS
LEFT IN THE BRAZIER AFTER REPEATING THE IGNITION OPERATION.
For the brazier to be cleaned properly, remove it from its housing completely
and thoroughly clean all the holes and the grate on the bottom. If good quality
pellets are used, you will normally only need to use a brush to restore the
optimal operating conditions of the
component.
5.1.2. Check every 2/3 days
The frequency of cleaning depends on the type of installation/connection to the
flue pipe (e.g. more frequent with horizontal connection, less frequent with
vertical connection), on the number of working hours, level of power and type of
fuel used. Clean and empty the ash tray
"G"
being careful with hot ash.
The ash must be completely cold
for a vacuum cleaner to be used to remove
it. Only use models suited to sucking ashes.
We recommend emptying the
ash pan at intervals of no more than 2 or 3 days
.
Once the operation is finished, reinsert the ash pan below the grate making
sure it is inserted properly.
5.1.3. Cleaning the glass
For cleaning the ceramic glass, the use of a dry brush is recommended,
or if it is very dirty, the special spray detergent, applying a small quantity
then cleaning with a cloth.
