K.M.E. VSS 18, User Manual

Page: 28 / 36

28
CARDIOID 2 (VSS 18 preset no. 4 & VL 750 / VL 760 preset no. 1)
dual
cable
Out A
for rear
sub VB 18
Out B for front sub VB 18 Out B for front sub VB 18
dual
cable
Out A
for rear
sub VB 18
Setup consists of: 2x VSS 18 + 4x VB 18 + 2x VL 750 or VL 760
1. Set-up PA: - place a VSS 18 to the left and right side in front of the audience
(on solid underground)
- place one VB 18 to the front and one backwards next to VSS 18 (side by side
and front in line, see drawing);
Note!
Please mind the distance of 60 cm to the
systems among each other and the distance to the periphery (e.g. front of stage,
walls)
- place the top units each on a distance rod on the VB 18 in the mid-position or
each on a high stand (front in line)
2. Connection: - apply power supply connection always with the supplied PowerCon cable on
VSS 18 + VL 750 or VL 760 on one 16A fused electric circuit
- plug in the left + right audio signal (XLR cable) each on channel A on the
VSS 18, after this you have to link each audio signal with a XLR cable to the
top units (e.g. with a dual-cable from K.M.E., which includes the audio signal
and the power supply)
- connect the speaker output „Out A“ of VSS 18 each with a passive subwoofer
VB 18 with a Speakon cable for the rear channel and speaker output „Out B“
each with a passive subwoofer VB 18 for the front channel
- switch on the system components successively,
Note!
please turn down all
volume controls before switching on the system components to avoid an
undesirable sound reproduction, because the system components can start
in the “lock-function” (depending on adjustment), that means it may not react on
changes on the control panel
- after switching on the system components it is advisable to set the volume knobs
to „central click“ (=0dB) to have a defined volume level
- The volume control for „Out A” and „Out B” is pre-set by 0 dB and depends on
system volume control (master), but they are not adjustable