11
PRELIMINARY
K-CTRL
9.2 “C” Colour Mode
9.3 “SLA” DMX Slave Mode
Press the MODE button (5) until the first
digit on the display shows “C”, indicating
operation in “C” mode. Then choose one
of the 19 presets as shown in the list below
by using the UP/DOWN buttons (6/7).
Changing the setting becomes effective
directly. Knob (1) determines the output
level.
In “C” mode, the unit does not receive any
values from the DMX input but generates
related DMX values on the output
according to the selected pattern, so that
Press the MODE button (5) until the
display shows “SLA”, indicating operation
in “SLA” (SLAVE) mode. In this mode the
unit is set to DMX-channel 001 in order
to receive the signals from a master unit
of the Multiform LS series being in mode
“A” or “C”. The unit interprets CH1 as
Out1 level, CH2 as Out2 level and CH3
as Out3 level. CH4 is not in use, and the
potentiometer (1) is disabled.
C 0
all off
C10
MixG
C 1
Out1
C11
MixH
C 2
Out2
C12
MixI
C 3
Out3
C13
MixJ
C 4
MixA
C14
MixK
C 5
MixB
C15
MixL
C 6
MixC
C16
MixM
C 7
MixD
C17
MixN
C 8
MixE
C18
MixO
C 9
MixF
C19
All outputs full on
other similar units from the Multiform LS
series can show the same behaviour if
they are connected by DMX signal cables
and set to Slave Mode “SLA”.
NOTE: The “C” Mode is automatically
disabled and cannot be chosen when an
external DMX signal is received [DMX
indicator LED (3) is lit].
If you leave mode “C” for any reason and
come back later into mode “C”, the unit will
recall the last chosen mix (even if the unit
was switched off in between).
Available colour presets:
similar units from the Multiform LS series
can show the same behaviour if they are
connected by DMX signal cables and set
to Slave Mode “SLA”.
NOTE: The “C” Mode is automatically
disabled and cannot be chosen when an
external DMX signal is received [DMX
indicator LED (3) is lit].
If you leave mode “SLA” for any reason
and come back later into mode “C”, the
