Positive Door Trigger Input
Violet Wire
The Violet wire's functions are identical to the Green Door Trigger wire, with the sole
exception that it is an open door input to the control module for vehicles having Positive 12
volt door pin switches.
CONNECTION:
Connect the Violet wire to a wire in the vehicle which is common to all
the door pin switches. The correct wire for this type of dome light/door jamb pin switch
system will have 12 volts present when the doors are opened, and chassis ground when the
doors are closed. The correct wire will show this change when any of the doors are opened.
Note: If the car has a delay dome light the Circuit Bypass feature will allow the system to
be armed from the transmitter instantly and will start protecting the Violet wire circuit
when the dome light turns off.
In Last Door Arming mode, the sys-
tem arms 30 seconds after
the dome light turns off.
Page - 16
1
1
12
12
12
12
Driver
Pin
Switch
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
123456789012
To Chassis
Ground
Dome
Light
To Constant
12 Volt
Note: The Driver Pin Switch will often have an extra
wire; this circuit will activate the security system, but only
from the driver's door. This is the incorrect activation wire.
Passenger
Pin
Switch
Typical Positive Switching
Dome Light system
This is
the correct
Activation
Wire.
Page - 21
Please note that a Programmable Feature, the 3rd Channel Carjacking Feature (#21),
when turned ON, will add activation of the Anti-Carjacking Feature to the operation of the
3rd Channel Output, but only when the ignition switch is "on". The 3rd Channel Output
will operate regardless of whether the ignition switch is "on", or "off". This output will not
disarm the security system when activated.
CONNECTION:
For most applications an optional relay will be required; if so use the
diagram found on Page 8, and substitute "Pink wire" for "Gray wire".
Domelight Supervision Output
WHITE/BLACK WIRE
The White/Black wire illuminates the interior lights by use of an optional SPDT relay.
This feature will illuminate the interior
lights of the vehicle upon disarm
(and also duplicate the
confirmation flashes).
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
1234567890123
(-) or (+) Factory Domelight Wire
To (-) or (+)
as
configured
This connection may made at
the same point that Green
or Violet wire is made
87
30
To 12 Volt
Positive
White/Black
wire
85 87a 86
To (-) or (+)
as needed
Dome
Light
Control
Unit
