JVC UX-A10DVD, Service Manual

Page: 30 / 90

1-30
UX-A10DVD
Removing the insulators from the four notches of the
traverse mechanism chassis. 1.
<Traverse mechanism assembly section> <Traverse mechanism assembly section>
Removing the insulator (See Fig.16)
Remove the screw K attaching the shaft holder (F) on
the back of the traverse mechanism assembly.
Move the shaft inward and release from the shaft holder
(R).
Bring up the one side of the pickup unit on the shaft to
release the joint
j on the opposite side. Then, remove
the pickup unit with the shaft.
1.
2.
3.
Removing the pickup unit (See Fig.17)
Pull out the shaft from the pickup.
Remove the two screws L attaching the rack spring
to the pickup.
1.
2.
Removing the pickup (See Fig.18)
Before disconnecting the flexible wire
connected to the pickup, solder the shorting
round point to protect the pickup from static
electricity. CAUTION:
Fig.16
Fig.17
Fig.18
L
K
Insulator
Insulator
Joint j Pickup guide
Pickup unit
Shaft holder(F)
Shaft holder(R)
Pickup unit
Traverse mechanism chassis
Shaft
Pickup
Rack spring