JVC RX-ES1SL Instructions Manual Download Page 97

Page: 97 / 280

English

Adjust the volume

To increase the volume, turn MASTER VOLUME control
clockwise (or press on the remote control).

To decrease the volume, turn MASTER VOLUME control
counterclockwise (or press VOLUME – on the remote
control).

CAUTION:

Always set the volume to the minimum before starting any sources.
If the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.

NOTE

The volume level can be adjusted within the range of “0” (minimum) to
“50” (maximum).

Listening with headphones

Connect a pair of headphones to the PHONES jack on the front
panel

This cancels the Surround mode currently selected,

deactivates speakers, and activates the HEADPHONE mode.
The HP (headphone) indicator lights up on the display.
• Disconnecting a pair of headphone from the PHONES jack cancels

the HEADPHONE mode and activates the speakers.

HEADPHONE mode

When using the headphones, the following signal is output
regardless of your speaker setting:
— For 2 channel sources, the front left and right channel signal is

output directly from the left and right headphones.

— For multi-channel sources, the front left and right, center and

surround channel signal is down-mixed and then output from
the headphones without missing bass element.
You can enjoy multi-channel sound source using the
headphones.

SUBWFR LFE

VOL

DOLBY D

DGTL AUTO

DGTL DTS

DGTL D.D.

CAUTION:

Be sure to turn down the volume:
• Before connecting or putting on headphones, as high volume can

damage both the headphones and your hearing.

• Before removing headphones, as high volume may output from the

speakers.

Selecting the digital decode mode

If the following symptoms occur while playing Dolby Digital or DTS
Digital Surround software with “DGTL AUTO” selected (see page 13),
follow the procedure below:
• Sound does not come out at the beginning of playback.
• Noise comes out while searching for or skipping chapters or tracks.

From the remote control ONLY:

Press ANALOG/DIGITAL INPUT to select “DGTL
AUTO.”

Press DECODE to select “DGTL D.D.” or “DGTL
DTS.”

• Each time you press the button, the digital decode mode

changes as follows:

• To play back software encoded with Dolby Digital, select “DGTL

D.D.”

• To play back software encoded with DTS Digital Surround,

select “DGTL DTS.”

NOTE

When you turn off the power or select another source, “DGTL DTS” or
“DGTL D.D.” is canceled and the digital decode mode is automatically
reset to “DGTL AUTO.”

The following are the analog/digital signal format indicators on the
display to indicate what type of signal comes into the receiver.

ANALOG:

Lights when analog input is selected.

LPCM:

Lights when Linear PCM signal comes in.

DOLBY D:

• Lights when Dolby Digital signal comes in.
• Flashes when “DGTL D.D.” is selected for software

not encoded with Dolby Digital.

DTS:

• Lights when DTS signal comes in.
• Flashes when “DGTL DTS” is selected for software

not encoded with DTS.

NOTE