JVC NX-BD3, Instructions For Network Function

Page: 22 / 24

21
You can activate the main unit remotely when the
previously used server has stopped.
1
Press [
J
/
K
/
H
/
I
] to select a
server.
“ ” refers to the stopped server.
2
Press [ENTER].
“CANCEL”/“WAKEUP”/“DELETE” pop-up menu
is displayed.
3
Press [
J
/
K
] to select “WAKEUP”.
When the main unit is activated, “ ” will change
to “ ” or an icon retrieved from the server.
NOTE
• You can also assign arbitrary values as the IP
addresses by following pages 11 to 15.
• To use wakeup on LAN, appropriate settings must
be made at the server.
• For details, please refer to the instruction manual of
the server you are using.
This part explains the procedure for connecting the
main unit to the computer directly.
You must install CyberLink Media Server to your
computer before connecting the main unit to the
computer. (Refer to page 7.)
1
Connect the main unit and the
computer as shown in the diagram
below.
2
Set up the computer so that it can
obtain its IP address automatically.
Select “Obtain an IP address automatically” in
step 6 on page 13, and then click [OK].
3
Set up the main unit so that it can
obtain its IP address automatically.
Select “DHCP”, and then click [ENTER] in step
5 on page 14. (“DHCP” is selected as the initial
setting.)
The main unit and the computer start to obtain
the IP addresses recognizable by each other.
Wait about one minute until the setup is
complete.
NOTE
• You can also assign arbitrary values for the IP
addresses by following pages 11 to 15.
* Use a shielded twisted-pair (STP) Ethernet cable.
* Use a crossover cable when connecting the main
unit directly to the computer.
4
Confirm the connection to the
computer.
Set up the shared folders referring to
“Specifying the shared folders” on page 8 and
“Confirming the connection to the computer” on
page 10.
• After finishing the shared folder setup, proceed
to “Playing back files stored on the computer”
on page 16.
Wakeup on LAN
NAVIGATION
Server View(Icon)
SUB MENU
SELECT ENTER
SERVER NAME : DNLA PC SERVER 1
DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER
DLNA PC SERVER DLNA PC SERVER
Network
NAVIGATION
Server View(Icon)
SUB MENU
SELECT ENTER
SERVER NAME : DNLA PC SERVER 1
DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER
DLNA PC SERVER DLNA PC SERVER
Network
WAKEUP
DELETE
CANCEL
NAVIGATION
Server View(Icon)
SUB MENU
SELECT ENTER
SERVER NAME : DNLA PC SERVER 1
DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER DLNA PC SERVER
DLNA PC SERVER DLNA PC SERVER
Network
Connecting the main unit to
the computer directly
Ethernet cable
(crossover cable, not
supplied)*
NX-BD3_network.book Page 21 Friday, August 8, 2008 9:28 AM