JVC MC-8100U, Service Manual, Page: 55 / 100

MC-8100U
2.3.3 Erasing the Trouble History
The error history can be cleared by pressing ENTER key for more than 5 seconds during displayed error history.
2.3.4 Error code list
2-18
01 UP/DOWN rotary sensor does not change
02 Left slit sensor does not change
03 Right slit sensor does not change
C U 04 UP/DOWN motor does not function
05 UP/DOWN motor doesn’t work correctly or rotary sensor defective
08 UP/DOWN operation exceeds the predetermined duration
09 Upper or lower limit sensor turn on during UP/DOWN operation
10 Tray lock release not possible
C L 11 Tray lock impossible, or lane change not possible
12 Tray lock does not exist at the initial position during carrier movement
20 Catcher (right
a
left) movement operation exceeds the predetermined duration
21 Catcher (left
a
right) movement operation exceeds the predetermined duration
22 Catcher (right
a
left) convergence operation exceeds the predetermined duration
23 Catcher (left
a
right) convergence operation exceeds the predetermined duration
24 Catcher (right
a
left) tray rotary sensor does not change
25 Catcher (left
a
right) tray rotary sensor does not change
C C 26 Right catcher sensor does not turn on
27 Left catcher sensor does not turn on
28 Catcher motor (right
a
left) does not function
29 Catcher motor (left
a
right) does not function
30 Tray does not exist
31 Magazine insertion incomplete, or sensor defective
41 Destination-unknown tray exists on the carrier
C
D 42 No disc in the tray
43 Flip tray does not exist
80 During the flip raise operation, the expected time required is over
F
81 During the flip descent operation, the expected time required is over
E 50 Mail Slot ejecting is not possible
M L 51 Mail Slot loading is not possible
T 52 Destination-unknown tray exists in the Mail Slot
60 Destination-unknown tray exists in the Drive and the control cable of the Drive is disconnected.
T
61 Tray removal is not possible at the drive position
C 62 Disc clamp of the drive does not function
(D#)
E 63 Drive ejection is not possible
D 64 Failure to remove the disc from the drive
S 65 Spindle motor fails to stop
P T 72 Destination-unknown tray exists in the Label Printer
Device Description
Device
part
Error
code
*1: # represents the drive number.
*2: Check the magazine loading condition.
*2
*1