JVC MC-8100U, Service Manual, Page: 27 / 100

23
ENGLISH
8. SETUP OF SCSI ID NUMBER OF THE MAIN UNIT
The SCSI ID No. set for the main unit (changer) can be modified as described below.
1.
In the normal display mode, press the MODE key.
(The menu display appears.)
2.
Press the SELECT key 5 times.
("6. ID No. SET MODE” appears.)
3.
Press the ENTER key.
(Select “6. ID No. SET MODE".)
4.
Press and hold the SELECT key for more than 5 sec-
onds.
(Wait until the display starts to blink.)
5.
Release the SELECT key when the current ID No. ap-
pears.
6.
Select a new ID No. using the keys 0 to 7.
7.
Press the ENTER key. (The ID No. being displayed is
entered.)
• The set ID No. becomes effective from the next time
power is turned on.
• The new SCSI ID No. should not conflict with the ID Nos. of other SCSI devices existing on the same SCSI bus.
C H A N G E R I D N o .
I S S E T T O 3
C H A N G E R
S C S I I D N o . = 0
1 . N O R M A L D I S P L A Y
2 . E R R O R D I S P L A Y
6 . I D N o . S E T M O D E
7 . C O U N T D I S P L A Y
P U S H S E L E C T K E Y
T O C H A N G E I D N o .
P U S H S E L E C T K E Y
T O C H A N G E I D N o .
C H A N G E R
S C S I I D N o . = 3 .
8-1. Display for checking the SCSI ID numbers
1.
In the normal display mode, press the MODE key.
(The menu display appears.)
2.
Press the SELECT key twice.
("3. ID No. DISPLAY” appears.)
3.
Press the ENTER key.
(Select “3. ID No. DISPLAY".)
The following information is displayed.
CH: Changer
DR1 to 4: Drives 1 to 4 ("-” indicates “Not Connected".)
The SCSI ID Nos. set for the main unit (changer) and installed drive units can be checked as described below.
1 . N O R M A L D I S P L A Y
2 . E R R O R D I S P L A Y
3 . I D N o . D I S P L A Y
4 . P A N E L O P E N M O D E
C H D R 1 2 3 4
0 1 2 – –