JVC MC-8100U, Service Manual, Page: 46 / 100

MC-8100U
Interlock
release bar
2.1.16 How to Operate with the Door Open (for Servicing)
For safety this unit is designed so as not to be operated with
the door open. When operating the unit with the door open for
maintenance or servicing, proceed in the following manner.
1. Open the door. (Refer to 2.1.2.)
2. Remove a interlock release bar on the center panel which
turns the interlock switch to ON.
3. With the door open, insert a interlock release bar into the
interlock switch hole located at the left side.
4. With this operation, the unit enters the mode in the same
way as with the door closed, and you can operate the unit as
normally.
2.1.15 Removing the U/D Motor
1. Remove the carrier mechanism. (Refer to 2.1.6.)
2. Remove the power supply unit. (Refer to 2.1.10.)
3. Remove the mail slot. (Refer to 2.1.13.)
4. Remove the screws
*
,
(
and
)
of the magazine stay, then
remove the connector from the U/D mechanism ass'y.
6. Remove the screw
¤
of the U/D mechanism ass'y and the
screw
‹
of the pulley unit. At this time, be sure to hold the
carrier base by hand. (Otherwise, the carrier mechanism may
be dropped.)
Remove the belt to pull out the U/D ass'y and the pulley unit,
and remove the sensor of the U/D ass'y. Then remove the
belt between the U/D ass'y and the pulley unit.
5. Remove the screw
⁄
of the motor cover, then remove the
magazine stay and the motor cover.
(
*
)
⁄
¤ ‹
Interlock switch hole
2-9