1-24 (No.MA387<Rev.003>)
3.2.20 Removing the spindle motor assembly
(See Figs.27 and 28)
• Remove the top cover, base board, chassis unit and clamper
assembly.
(1) From the top side of the chassis unit, turn the turn table
from side to side and remove the two screws
M
attaching
the spindle motor assembly through the hole of the turn ta-
ble. (See Fig.27.)
(2) From the bottom side of the chassis unit, turn the change
gear 2 in the direction of the arrow 2 while pulling the trigger
arm in the direction of the arrow 1 and let the pickup move
in the direction of the arrow 3. (See Fig.28.)
(3) Slide the spindle motor assembly in the direction of the ar-
row and take out it in an upward direction from the chassis
unit. (See Fig.28.)
Reference:
Remove the wires from the soldered sections
c'
on the base
board and remove them from the sections (
d'
,
e'
) on the chas-
sis unit as required.
Fig.27
Fig.28
M
Turn table
Chassis unit
Wire(black)
d'
e'
Wire(red)
Spindle motor assembly
Change gear 2
Trigger arm
Chassis unit
Pickup
Base board
c'
2
1
3
Summary of Contents for KD-BT11E
Page 29: ... No MA387 Rev 003 1 29 ...
Page 66: ... M E M O ...
