14
EN
Master Page: Left
1
Adjust the velcro strip.
2
Pass your right hand through the loop and grasp
the grip.
3
Adjust your thumb and fingers through the grip to
easily operate the Recording Start/Stop Button,
Power Switch, SNAPSHOT and Power Zoom
Switch. Be sure to fasten the velcro strip to your
preference.
NOTE:
The grip can rotate 90º downward. It is useful to
shoot images below.
To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise.
●
Some tripods are not equipped with studs.
While using the LCD monitor:
Make sure the viewfinder is pushed back in. Press
PUSH OPEN
and open the LCD monitor fully. It can
rotate 270º (90º downward, 180º upward).
While using the viewfinder:
Make sure the LCD monitor is closed and locked.
Pull out the viewfinder fully.
●
Be sure to pull out the viewfinder until you hear a
click, otherwise it may be pushed back in during
use.
Grip Adjustment
Tripod Mounting
CAUTION:
When attaching the camcorder to a tripod, extend
its legs to stabilize the camcorder. It is not advised
to use small sized tripods. This may cause damage
to the unit by falling over.
LCD Monitor And Viewfinder
180˚
PUSH OPEN Button
JY-HD10US.book Page 14 Tuesday, April 22, 2003 8:18 AM
