JVC HR-DVS2EU, Instructions Manual

Page: 79 / 88

EN
79
CORRECTIVE ACTION
Re-perform the clock and/or timer
settings.
Press
‰
and confirm that "
‰
" is
displayed on the display panel.
Set the channel position other than
"F-1" before engaging to Timer-
Standby mode.
Timer programming can’t be
performed while a timer recording is
in progress. Wait until it finishes.
VHS deck
Load a cassette with the Record
Safety tab intact, or cover the hole
using adhesive tape.
DV deck
Load a cassette with the erase
protection switch set to "REC".
Remove the cassette and cover the
hole with adhesive tape, or insert a
cassette with the Record Safety tab
intact.
Remove the cassette and set the erase
protection switch to "REC".
Check the programmed data and re-
program as necessary, then press
‰
again.
The programme may not have been
recorded in its entirety. Next time
make sure you have enough time on
the tape to record the entire
programme.
Refer to "Guide Program Number Set"
and re-perform the procedure
(
pg. 67).
SYMPTOM
1. Timer recording won’t work.
2. Timer programming is not possible.
3. "
‰
" and "
]
" on the display panel
won’t stop blinking.
4. The cassette is automatically
ejected, and "
‰
" and "
]
" on the
display panel won’t stop blinking.
5. "
‰
" blinks for 10 seconds and the
Timer mode is disengaged.
6. The cassette is automatically
ejected, the power shuts off and
"
‰ " and " ] " won’t stop blinking.
7. The S
HOW
V
IEW
system does not
timer-record properly.
POSSIBLE CAUSE
●
The clock and/or the timer have
been set incorrectly.
●
The timer is not engaged.
●
Timer Recording may not work
when the recorder’s input mode is
set to "F-1" for recording on the DV
deck, because the recorder is
waiting for the signals through
DV IN/OUT (i.Link) connector.
●
Timer recording is in progress.
●
The timer is engaged but there’s no
cassette loaded.
●
VHS deck
The loaded cassette has had its
Record Safety tab removed.
●
DV deck
The loaded cassette has had its erase
protection switch set to "SAVE".
●
‰ has been pressed when there are
no programs in memory, or the timer
record information has been
programmed incorrectly.
●
The end of the tape was reached
during timer recording.
●
The recorder’s channel positions
have been set incorrectly.
TIMER RECORDING
CORRECTIVE ACTION
Set "SOUND MODE" to "12BIT" at
the original recording (
pg. 25).
Set the tape speed to SP (DV cassette)
or SP/LP (VHS/S-VHS cassette) at the
original recording.
Monitor the sound using the
connected devices.
Perform Random Assemble Editing
again.
POSSIBLE CAUSE
●
"SOUND MODE" on the DV Mode
Set Menu had been set to "16BIT" at
the original recording.
●
The tape speed had been set to LP
(DV cassette) or EP (VHS/S-VHS
cassette) at the original recording.
●
This is normal.
●
The memory backup time has
expired.
●
This is normal.
SYMPTOM
5. Audio dubbing is not possible.
6. Monitoring the audio-dubbed
sound is not possible during audio
dubbing using the DV deck.
7. The programmed memory of
Random Assmble Editing is
disappeared.
8. When performing Tape Dubbing,
the beginning of the dubbing start
point is not dubbed.
RECORDING