23
2. CONTROLS, INDICATORS AND CONNECTORS
CAUTION:
2-6 Rear Section (Cont'd)
When connecting a component that does not r48
V power supply, make sure that the switch is not set to this
position before the connection is made.
1
4
3
2
No.
Signal
GND
—
—
+12V
1
2
3
4
6
[AUDIO IN FRONT LINE/MIC] AUDIO IN FRONT
select switch
Selects the audio signal input to the AUDIO IN FRONT
connector
3
on page 10.
LINE
: Set to this position when connected to audio
equipment, etc. The reference input level is +4 dBs.
MIC
: Set to this position when the microphone is
connected. The reference input level is -60 dBs.
MIC +48V ON
:
Set to this position when a microphone req48
V power supply (phantom microphone, etc.) is
connected. This connector su48 V DC
current.
Use this setting when using the provided
microphone.
7
[INTERCOM] intercom input terminal (XLR 5-pin)
Input terminal for the intercom headset.
Connect the JVC Intercom KA-310 to this terminal.
This terminal is enabled when the VTR/RM connector (26-
pin) on page 21 is connected to the camera control unit.
(Enabled when the MODE switch
6
on page 20 is set to
RM.)
8
[DC INPUT] connector (XLR 4-pin)
Power input connector for 12 V DC. Connect with the AA-
P250 optional AC power adapter. When a cable is connected
here, the power supply from the battery pack is interrupted
and the source is switched to the power supplied through
this connector.
When supplying power to the unit from this connector or
battery, set the POWER switch
1
on page 20 to DC IN/
BATT..
9
Battery holder
Mount a Flat Shape type battery pack here.
When supplying power to the unit from DC INPUT connector
8
or battery- set the POWER switch
1
on page 20 to DC
IN/BATT.
☞
See "Attaching a Flat Shape Type Battery Pack" on page
38.
0
Battery holder lock release knob
This knob is used to open the battery case cover. Press the
knob to open the cover.
!
[BREAKER]
The breaker trips when the power consumption exceeds
the capacity.
If the breaker trips, confirm that the power consumption
does not exceed the wattage rating. Then press BREAKER
before turning the power ON again to put the camera in the
operating status.
If the unit still does not work normally, please consult the
person in charge of professional video equipment at your
nearest JVC-authorized service agent.
