79
11. MENU SCREENS
TEST TONE
AUDIO MODE
A.OUT
AT SEARCH
CH1 FRONT
VR
WIND CUT
Item
Function
Variation Range
Initial Setting
SKIN COLOR
DET.
SKIN COLOR
RANGE
PAGE BACK
Sets whether it is possible to change the color used by the Skin Tone
Detail function.
EXECUTE : Choose this setting to allow detection of the color used by
the Skin Tone Detail function.
STOP
: Choose this setting to stop detection of the color used by the
Skin Tone Detail function.
☞
See “Using the Skin Detail Function” on page 95.
The setting of this item can only be changed when the SKIN COLOR
DET. item is set to EXECUTE.
This setting is for adjusting the skin color range where Skin Tone Detail
functions. (When this item is selected, the area where the Skin Tone Detail
function is applicable is indicated by zebra patterns on the screen.)
While viewing the zebra pattern range, perform the adjustment.
Increasing the range ........ Increase the number
Increasing the range ........ Decrease the number
The ADVANCED PROCESS menu screen returns when the SHUTTER
dial is pressed with the cursor at this position.
STOP
EXECUTE
WIDE
11
to
NORMAL
to
–11
NARROW
–––––
STOP
NORMAL
–––––
11-8 SKIN COLOR ADJUST Screen
11-9 AUDIO/VIDEO Menu Screen
Item
Function
Variation Range
Initial Setting
OFF
ON
32K
48K
OFF
ON
DISABLE
ENABLE
OFF
FRONT
REAR CH1
REAR CH2
ALL
OFF
48K
ON
ENABLE
OFF
Sets whether or not the audio reference signal (1kHz, –20dBFS or
–12dBFS) should be output while the color bar is output.
OFF : Audio reference signal is not output.
ON : Audio reference signal is output.
Selects the sampling frequency for audio recording (both CH-1 and CH-
2)
32K : Recording is performed with 12-bit, 32 kHz sampling frequency
48K : Recording is performed with 16-bit, 48 kHz sampling frequency
* The DV format offers recording tracks for up to 4 channel when using
12-bit, 32 kHz sampling. The GY-DV5100 records two of these track.
The GY-DV5100 does not allow after-recording.
Selects whether or not audio should be output during search.
(Including slow playback)
OFF : Audio is not output
ON : Audio is output
Used to select whether or not the front section audio level control should
be operative. The front section audio level control only affects the audio
signal recorded on CH-1.
DISABLE : Use of the front section audio level control is disabled.
ENABLE : Use of the front section audio level control is enabled.
* The operation of the CH-1 audio level control on the side section is
unaffected by this setting.
To select whether or not the low frequencies of the audio signal from the
audio input connectors are cut. Set to ON to reduce the wind noise of the
microphone.
OFF
: Low frequencies are not cut.
FRONT
: Only the low frequencies of the audio signal input to the
FRONT MIC IN connector are cut.
REAR CH1 : Only the low frequencies of the audio signal input to the
CH-1 REAR AUDIO IN connector are cut.
REAR CH2 : Only the low frequencies of the audio signal input to the
CH-2 REAR AUDIO IN connector are cut.
ALL
: The low frequencies are cut for both the FRONT and REAR
AUDIO IN connectors.
e11_dv5100u(71_87)e.p65
12/10/04, 2:29 PM
79
