EN
11
Charging Environment
Perform charging where the temperature is between 10° and 30°C (50°F and 86°F). 20° to 25°C (68°F to 77°F) is
the ideal temperature range for charging. If the environment is too cold, charging may be incomplete.
Continuous Shooting
Continuous shooting is possible (See table below for recording time) under the following conditions:
• A BN-V814U Battery Pack is in use
• The temperature is approximately 20°C/68°F
However, . . .
• If the temperature is below 10°C/50°F, or
• If zoom or Record-Standby are engaged or LCD monitor is used repeatedly, continuous shooting capability
is reduced significantly. Before extended use, it is recommended that you prepare enough battery packs to
cover 3 times the planned shooting time.
Installing The Battery Pack
The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has
been charged fully.
1
OPEN BATTERY COVER
Slide the open switch.
2
INSERT CHARGED BATTERY
Insert the
mark end of the battery first until
you hear a click. The hook rises. Inserting the
battery backwards will result in malfunction.
3
CLOSE BATTERY COVER
Battery
Battery cover
Hook
Open switch (BATTERY)
NOTES:
●
To remove the battery, turn off the camcorder,
open the battery cover and push down the hook.
●
Be careful not to drop the battery pack.
●
The hook is tight to prevent the battery from
dropping.
No. of batteries to supply power
Using one battery installed in the camcorder
Using two batteries; one in the camcorder and
one in the Power Pack (optional) attached to the
camcorder
Approximate recording time (unit: min)
LCD monitor off/
Viewfinder on
100
180
LCD monitor on/
Viewfinder off
80
140
Summary of Contents for GR-DVL9000
Page 90: ...90EN MEMO ...
Page 91: ...EN 91 MEMO ...