EN
13
GETTING STARTED
MasterPage: Start_Right
GETTING
ST
AR
TED
How To Attach The Core Filter
Attach the core filters to the cables. The core
filter reduces interference.
1
Release the stoppers on both ends of the
core filter.
2
Run the cable through the core filter, leaving
approx. 3 cm (1-3/16") of cable between the
cable plug and the core filter.
Wind the cable once around the outside of the
core filter as shown in the illustration.
3
Close the core filter until it clicks shut.
NOTES:
●
Take care not to damage the cable.
●
When connecting a cable, attach the end with the
core filter to the camcorder.
This camcorder’s 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging The Battery Pack
1
Set the Power Switch to “OFF”.
2
With the arrow on the battery pack pointing
right, push the battery pack slightly against the
battery pack mount
a
.
3
Slide the battery pack to the right until it locks
in place
b
.
4
Connect the AC Adapter to the camcorder.
5
Plug the AC Adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
6
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.
Stopper
3 cm (1-3/16")
Wind once.
Core filter
Power
POWER/CHARGE lamp
Battery pack
BATT. RELEASE
Open the
cover.
Power switch
mark
Arrow
Battery pack mount
To
DC connector
To AC outlet
AC Adapter
CONTINUED ON NEXT PAGE
GR-DF470-450US.book Page 13 Thursday, February 24, 2005 11:26 AM
