39
(Continued)
Setting and Adjusting Surround Mode
1
Press
to select "SURR" (Sur-
round Speaker) or "SUBWFR"
(Sub-woofer).
• "SUBWFR" can only be selected when
playing back a multi-channel DVD with a
sub-woofer audio signal.
2
Select
or
to adjust the
volume.
Adjust the volume between -6 to +6.
• It will return to sound source display in a
few seconds.
NOTE
• In the following situations, "SUBWFR" cannot be
adjusted.
• "SUB WFR" is set to "OFF" in "Other Settings"
on the right.
• The sound source with stereo sound is played.
• The sound source is DVD/CD and the disc is
stopped.
1
Press .
2
Select a setting item by pressing
or
.
3
Press
to set or adjust the
level.
BAL:
Turning down the volume of the left or right
speaker. To turn down the volume of the right
speaker, press
(R-1-R-21), to turn down the
volume of the left speaker, press
(L-1-L-21).
The volume level changes each time the button is
pressed. When the balance is right, it displays
"CENTER".
SUB WFR:
When a sub-woofer is connected to the unit, select
"ON".
When a sub-woofer is not connected, select
"OFF".
DEC1, 2:
This allows you to set to the decode mode when
external equipment connected to Digital 1 or 2
uses Dolby Digital or DTS, or when an equipment
such as a BS digital tuner is connected to Digital 1
or 2. It is helpful in the following situations:
• When the sound is not audible at the beginning
of the playback.
• When noise is heard when selecting a chapter.
AUTO/PCM:Normally this mode should be
selected.
DTS:
This mode should be selected when
the sound is DTS. Other sounds than
DTS are not heard.
• It allows you to return to source (sound source)
display a few seconds later.
For the locations of remote control
buttons, refer to page 38.
Adjust the Volume for Each
Speaker
Other Settings
Adjust the volume balance of the front
speakers.
Set whether a sub-woofer is to be used.
Set the decode mode for Digital 1
Terminal.
Set the decode mode for Digital 2
Terminal.
NX-DD30[UB].book Page 39 Friday, November 25, 2005 10:26 AM
