22
2 Preparation
It is easy to permanently adjust the amount of water for all
single
products
to the cup size. Adjust the amount once as shown in the
following example. Every time you prepare a drink in the future, this
amount will be dispensed.
Example:
Proceed as follows to
permanently
set the amount of
water for one coffee.
Precondition:
‘Please select product’
is displayed.
T
Place a cup under the coffee spout.
T
Press and
hold
the
‘Coffee’
button until
‘Enough coffee?
Press button’
appears.
T
Release the
‘Coffee’
button.
Preparation starts and the coffee flows into the cup.
E
When adapting specialty coffees with
milk,
you are prompted
to open the switch
l
at this point. When there is enough milk
foam in the cup, close the switch again.
T
Press any button as soon as there is sufficient coffee in the
cup.
Preparation stops.
‘Saved’
appears briefly on the display. The
set amount of water for one coffee is permanently stored.
‘Please select product’
appears on the display.
E
You can alter this setting at any time by repeating the above
procedure.
E
You can also permanently set the amount of water for all spe-
cialty coffees and hot water in programming mode (see Chap-
ter 4 ‘Permanent settings in programming mode – Adjusting
the product settings’).
You can adjust the grinder on a continuous scale to suit the degree
of roast of your coffee.
If you adjust the consistency of grind when the grinder is not oper-
ating, the grinder adjustment switch could be damaged.
T
Only adjust the consistency of grind when the grinder is run-
ning.
The consistency of grind is correct if the coffee flows regularly from
the coffee spout. In addition a fine, thick crema forms.
Permanently setting the
amount of water for the
cup size
Adjusting the grinder
CAUTION