• Light roast: use a finer adjustment (smaller dots).
• Dark roast: use a coarser adjustment (larger dots).
• Open the cover of the bean container (Fig. 1.9).
• To adjust fineness, turn the grinding wheel during grinding to
the desired position (Fig. 6).
ATTENTION:
Oily beans tend to stick together. Stir beans just
before grinding to ensure a proper flow of beans into the burrs.
Please note:
If coffee does not flow through the Dual Coffee
Spouts in a constant stream, turn the wheel to a coarser setting.
8. DAILY PREPARATION
Fill the water container every morning with fresh, cold water. This
will enhance the taste of your coffee.
• Make sure the Main Power Switch is on (Fig. 1b). In this case
the left button cluster is illuminated.
• Push the On/Off button (Fig. 3.2). The display shows
HEATING
.
After approx. 2 minutes the display shows
PRESS RINSE
and
the Rinse button illuminates.
• Push the Rinse Button (Fig. 2,E). Hot water will warm up all
internal parts and pump through the coffee spouts
RINSING
.
The water will be caught in the drawer underneath. The rinse
cycle stops by itself and the display reads
READY
. You are
now ready to make coffee.
8a. TURNING THE MACHINE OFF / RINSING
Always place cups under the Dual Coffee Spouts and the Auto
Cappuccino System (Fig. 17). When turning the C9 OT off, the
spouts that were used (coffee and/or milk) will be rinsed.
Only the Dual Coffee spouts were used
: The C9 OT displays
RINSING
. For a few seconds hot water will be dispensed
through the Dual Coffee Spouts. The C9 OT turns off (display
off, red light in left button cluster is on).
The Auto Cappuccino Spouts and the Dual Coffee Spouts
were used:
If the “Cappuccino Rinsing” cycle was not used
(chapter 10g) the C9 OT will first prompt
C CLEANING
(for
"Cappuccino" Cleaning) and the Rinse button illuminates
(chapter 15.2). If the Rinse button is not pushed within the next
ten seconds, the display shows
RINSING
and the Dual Coffee
Spouts are rinsed. Then the display shows
RINSE RIGHT
and
the Rinse button illuminates.
• Push the Rinse button. The C9 OT will dispense hot water
through the coffee spout of the Cappuccino system,
CAPPUCCINO RINSING
. The C9 OT turns off (display off,
red light in left button cluster is on).
9. COFFEE PREPARATION
9a. PRE-WARM CUPS
READY
In the morning pre-warm your cups with hot water feature. Cold
cups reduce the coffee temperature by 5ºF to 10ºF.
• Place your cup under the Auto Cappuccino system and push
the Hot Water button (Fig. 4)
WATER
.
• Push the Hot Water button again to stop and discard the
water
READY
.
14.
