Juniper WLA Series, Hardware Documentation

Page: 49 / 92

•
IEEE 802.11g
• IEEE 802.11af
• IEEE 802.11i
•
IEEE 802.11n
•
IEEE 802.11abgn
• IEEE 802.3i—10BASE-T Ethernet
• IEEE 802.3u—100BASE-TX Ethernet
•
IEEE 802.3ab—1000BASE-TX Gigabit Ethernet
•
IEEE 802.3af—Power over Ethernet
• IEEE 802.3at—Power over Ethernet
• IEEE 802.3az—Energy Efficient Ethernet
Related
Documentation
Agency Approvals for WLA Series Access Points on page 35
•
WLA Series Access Point Radio Frequency Exposure Guidelines
The following are radio frequency exposure guidelines for the WLA Series access points:
Wireless LAN Access Point (WLA) Radio Safety Advisories:
Federal Communications Commission (FCC) Docket 96-8 for Spread Spectrum
Transmitters specifies a safety standard for human exposure to radio frequency
electromagnetic energy emitted by FCC-certified equipment. When used with the proper
antennas (shipped in the product), Juniper Networks WLA Series Access Point products
meet the uncontrolled environmental limits found in OET-65 and ANSI C95.1-1991. Proper
installation of the access point according to the instructions in this manual will result in
user exposure that is below the FCC recommended limits.
Article 12—Without permission granted by the NCC, any company, enterprise, or user is
not allowed to change frequency, enhance transmitting power or alter original
characteristics as well as performance of an approved low power radio-frequency device.
Article 14—The low power radio-frequency device shall not influence aircraft security
and interfere legal communication; if such influence or interference is found, the user
shall cease operating immediately until no interference is achieved. The said legal
communications means radio communications are operated in compliance with the
37 Copyright © 2012, Juniper Networks, Inc.
Chapter 6: Certifications for the Access Point