•
Flags any missing required configuration when you attempt to leave a page.
•
Indicates which configuration elements or tasks are unavailable to you based on your
previous selections by graying them out.
You can choose one of the following setup modes to configure the services gateway:
•
Default Setup mode—This mode allows you to quickly set up a services gateway in a
default security configuration. In this mode, you can configure basic system settings,
such as the administrator password, and download purchased licenses. Any additional
configuration can be carried out after completing the wizard setup.
•
Guided Setup mode—This mode allows you to set up a services gateway in a custom
security configuration.
NOTE:
It is mandatory to configure only the device name and root password.
You can skip all the other steps by clicking Next to go directly to the Confirm
& Apply page to apply the configuration.
About the Default Setup Mode
If you choose the Default Setup mode, the wizard takes you through the minimal
configuration needed to set up the services gateway to securely pass traffic in the default
configuration. The resulting configuration is similar to the factory-default configuration
described in
“SRX110 Services Gateway Software Configuration Overview” on page 83
,
except that the untrust and trust zones are renamed the Internet and Internal zones,
respectively.
In the Default Setup mode, you configure:
•
Device name
•
Password for the root account
•
Time information for the services gateway location
•
Local time zone
•
Name or IP address of a Network Time Protocol (NTP) server, if NTP is used to set
the time on the services gateway
•
Local date and time if an NTP server is not used to set the time
You cannot do additional configuration in the Default Setup mode. You must commit
your changes and exit the wizard to perform any additional configuration. You can perform
additional configuration by rerunning the wizard in the Guided Setup mode, by using the
J-Web interface, or by using the CLI.
See the
SRX110 Services Gateway Quick Start
for step-by-step instructions on how to
configure your services gateway in the Default Setup mode.
Copyright © 2015, Juniper Networks, Inc.
100
SRX110 Services Gateway Hardware Guide for H2 Model Numbers