Juniper SRX100, Hardware Manual, Page: 80 / 154

NOTE: You must manually configure the IP address for the management port you
are using before you save your initial configuration. When you save the configuration
for the first time, you will lose the connection to the services gateway if you have
not manually configured the IP address. If you lose the connection through the
management interface, you must connect through the console port.
Related Topics
■
SRX100 Services Gateway Basic Connectivity Overview on page 55
■
Management Access for the SRX100 Services Gateway on page 59
■
Connecting an SRX100 Services Gateway to the CLI Locally on page 62
■
Connecting an SRX100 Services Gateway to the CLI Remotely on page 64
■
Configuring Basic Settings for the SRX100 Services Gateway with J-Web Quick
Configuration on page 67
Connecting an SRX100 Services Gateway to the CLI Locally
If you plan to use the CLI to configure the SRX100 Services Gateway, you must
connect through the console port, as shown in Figure 14 on page 62.
Figure 14: Connecting to the Console Port on an SRX100 Services Gateway
NOTE: Figure 14 on page 62 shows a connection to a local management device. A
remote connection to the services gateway through a modem requires the cable and
connector shown (provided in the services gateway accessory box), plus a DB-9
female to DB-25 male (or similar) adapter for your modem, which you must purchase
separately.
62 ■
Connecting an SRX100 Services Gateway to the CLI Locally
SRX100 Services Gateway Hardware Guide