Errata
65
Release 10.0.3
The
JUNOSe Command Reference Guide N to Z
omits the following information
for the
qos-interface-parent
command, beginning with JUNOSe Release 9.2.0
in which it was introduced:
The
qos-interface-parent
command is available in Interface Configuration
mode, as well as in QoS Interface Set Configuration and QoS Interface Superset
Configuration modes. The syntax for this command in Interface Configuration
mode is:
[ no ] qos-interface-parent
interfaceSetName
where:
interfaceSetName
—Name of the QoS interface set that is the parent of the
interface
This command assigns a QoS interface set as the parent for the member
interface. The
no
version deletes the parent from the interface.
The description of the
redundant-port
command in the
JUNOSe Command
Reference Guide N to Z
and
JUNOSe Link Layer Configuration Guide, Chapter 6,
Configuring 802.3ad Link Aggregation and Link Redundancy, Configuring Ethernet
Link Redundancy
section, inadvertently omits the default values of the following
keywords:
failover timeout:
1000 milliseconds
packet-sampling:
disabled
delay:
0 milliseconds
auto-revert:
disabled
The description of the
shaping-rate
command in the
JUNOSe Command
Reference Guide N to Z
incorrectly states the range and units for the
shapingRate
argument. The correct range for the
shapingRate
argument is 1–1000000000
bps/kbps. You can set the shaping rate to vary from 1 bps to 1000 gbps (which
is denoted by entering 1000000000 kbps in the CLI for this command).
In the
JUNOSe Command Reference Guide N to Z
for JUNOSe Release 9.3.x,
Release 10.0.x, and Release 10.1.x, the description of the
fileName
variable in
the
service check-config
command incorrectly stated that it represented an
action for an empty service name tag. The
fileName
variable available with this
command refers to the name of an existing configuration file (.cnf) that needs
to be validated for corruption.
The tables in the
Interface Types and Specifiers
section of
Chapter 1, Command
Reference Topics
, in the
JUNOSe Command Reference Guide
erroneously state
that the maximum number of PPPoE subinterfaces per Ethernet (GE/FE) line
module is 4094. The correct number for an ERX router is 8000 and for an E120
or E320 router, it is 16,000.
