JUNOSe 10.0.3 Release Notes
26
Known Behavior
MPLS
Martini circuits configured on the ES2 10G LM act as true layer 2 tunnels,
without modifying the layer 2 headers. For this reason, Martini VLAN retagging
is not currently supported.
If you are upgrading to Release 7.1.0 or a higher-numbered release from a
release numbered lower than Release 7.1.0, and have inter-AS option B or C
configurations, you must explicitly configure MPLS on all inter-AS links, as in
the following example:
host1#
configure terminal
host1(config)#
interface fastEthernet 2/0
host1(config-if)#
ip address
...
host1(config-if)#
mpls
If you do not explicitly configure MPLS on the links, the inter-AS feature will not
work properly.
Multicast
The
ip dipe sg-cache-miss
and
ipv6 dipe
commands are not intended or
supported for customer use, although they are visible in the User Exec and
Privileged Exec modes respectively. These commands are intended to be used
in a Juniper Networks internal lab environment for testing without a traffic
generator.
Do not configure a multicast group with more than 10,219 outgoing interfaces
(OIFS) on the same ES2 10G LM. [Defect ID 81768]
Packet Mirroring
The ES2 10G LM supports the packet mirroring feature when the module is
paired with the ES2-S2 10GE PR IOA, the ES2-S1 GE-8 IOA, or the ES2-S3 GE-20
IOA. When you use the ES2 10G LM with these IOAs, CLI-based
interface-specific mirroring is not supported.
When both interface-specific mirroring and user-specific mirroring are
configured on the same interface, the interface-specific secure policies take
precedence. The interface-specific secure policies, which you manually attach
using the CLI, override and remove any existing secure polices that were
attached by a trigger action. If the interface-specific secure polices are
subsequently deleted, the original trigger-based secure policies are not
restored.
