NOTE:
For information about configuring graceful Routing Engine switchover,
graceful restart, and nonstop active routing, see the Junos OS High Availability
Configuration Guide.
NOTE:
The first supported release for graceful Routing Engine switchover
and nonstop active routing on the M120 router is Junos OS Release 8.2 and
Junos OS Release 9.0, respectively. Graceful restart software requirements
are dependent on the routing protocols configured on the router. For the
minimum software requirements for graceful restart, see the Junos OS High
Availability Configuration Guide.
To take a host subsystem offline:
1.
Determine whether the host subsystem is functioning as the master or as the backup,
using one of the two following methods:
•
Check the Routing Engine LEDs on the craft interface. If the green
RE MASTER
LED
is lit, the corresponding host subsystem is functioning as the master.
•
The master Routing Engine is designated
Master
in the
Current state
field when you
issue the command:
user@host>
show chassis routing-engine
Routing Engine status: Slot 0: Current state
Master ...
2.
If the host subsystem is functioning as the master, switch it to backup using the CLI
command:
user@host>
request chassis routing-engine master switch
3.
On the console or other management device connected to the Routing Engine that is
paired with the CB you are removing, enter CLI operational mode and issue the
following command. The command shuts down the Routing Engine cleanly, so its
state information is preserved:
user@host>
request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
For more information about the command, see the
Junos OS System Basics and Services
Command Reference
.
NOTE:
The FEB might continue forwarding traffic for approximately 5
minutes after the
request system halt
command has been issued.
Copyright © 2010, Juniper Networks, Inc.
142
M120 Multiservice Edge Router Hardware Guide
All manuals and user guides at all-guides.com