Figure 44: M120 Routing Engine Management Ports and Alarm Relay
Contacts
Connecting the M120 Router to a Network for In-Band Management
To connect the Routing Engine to a network for out-of-band management, connect an
Ethernet cable with RJ-45 connectors to the
ETHERNET
port on the craft interface. One
such cable is provided with the router. For cable specifications, see “Routing Engine
Interface Cable and Wire Specifications for the M120 Router” on page 246. To connect the
Routing Engine to a network for out-of-band management:
1.
Turn off the power to the management device.
2.
Plug one end of the Ethernet cable (Figure 45 on page 85 shows the connector) into
the appropriate
ETHERNET
port on the CIP. Figure 46 on page 85 shows the external
device ports on the CIP. The ports labeled
HOST 0
connect to the Routing Engine in
the upper Routing Engine slot (
RE 0
), and the ports labeled
HOST 1
connect to the
Routing Engine in the lower Routing Engine slot (
RE 1
).
3.
Plug the other end of the cable into the network device.
Copyright © 2010, Juniper Networks, Inc.
84
M120 Multiservice Edge Router Hardware Guide
All manuals and user guides at all-guides.com