Juniper JSA3800, Hardware Manual, Page: 43 / 92

•
Installing the JSA3800 Appliance on page 32
•
Connecting the JSA3800 Appliance to Ground on page 41
Connecting the JSA3800 Appliance to a Management Device
You can control the JSA3800 appliance through a connected management device (such
as a laptop). Use the console port to connect your laptop as shown in
Figure 16 on page 43 .
Figure 16: Connecting the Management Device
For the location of the ports, refer to the JSA3800 Back Panel Components table in
“JSA3800 Appliance Back Panel Description” on page 21 .
NOTE: You can choose any GB ports as the management port.
To connect a management device with the JSA3800 appliance:
1.
Connect external devices using the ports on the back panel of the appliance.
2.
If you use a laptop, connect the laptop to the DB-9 serial console port on the back
panel.
3.
Plug an Ethernet cable into the network port on the back panel.
4.
Plug a RS-232 (DB-9 F/F) cable into the console port.
NOTE: When using a laptop to connect to the appliance, you must use a
terminal program, such as HyperTerminal, to connect to the appliance.
43 Copyright © 2019, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration