Juniper JSA3800, Hardware Manual, Page: 33 / 92

Figure 5: Connecting the AC Power Cord
NOTE: To connect DC power, see “Connecting the JSA3800 Appliance
to a DC Power Source” on page 41 .
3.
Plug the other end of the power cord into a wall socket.
4.
Plug the Ethernet cable into the Ethernet port on the back panel.
When you turn on the power, the internal port uses two LEDs to indicate the LAN
connection status, as shown in
Figure 6 on page 33 .
Figure 6: JSA3800 Front Panel LEDs
4— 1— Hard drive LED Information LED
5— 2— Power LED LAN2 LED
3—LAN1 LED
5.
Plug an RS-232 (DB-9 F/F) cable into the console port.
Table 12 on page 33 describes the details of the DB-9 console port pinouts for the
JSA3800 appliance.
Table 12: DB-9 Console Connector Pinouts for the JSA3800 Appliance
Description Signal Pin
Data Carrier Detect DCD 1
Receive Data RxD 2
33 Copyright © 2019, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration