Juniper JRR200, Hardware Manual

Page: 67 / 108

Table 23: Alarms for JRR200 Route Reflector Chassis Components (continued)
Alarm Severity Action Alarm Conditions Component
Steady red (major) Replace the power supply. A power supply has failed. Power supply
Install a power supply unit in the
empty slot. JRR200 route reflector
requires two power supply units to
be installed. A power supply unit is not
present.
Verify and ensure that the power
cord is connected properly. Power cord is not connected.
Yellow (minor) As it is a non-recoverable fault,
replace the power supply. Power supply fan failure.
Red (major)
•
Check the voltage of the power
source if it is in the operating
range.
• Open a support case using the
Case Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500
(from outside the United States).
Input failure to the power
supply
Yellow (minor) Open a support case using the Case
Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500 (from
outside the United States).
Power supply drawing more
current than it should.
Red (major) Open a support case using the Case
Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500 (from
outside the United States).
Unrecognized power supply
Red (major) Connect the power supply to the
power source. Power supply not powered
on.
Red (major) • Replace the power supply.
•
Open a support case using the
Case Manager link at
https://www.juniper.net/support/
or call 1-888-314-5822 (toll-free
within the United States and
Canada) or 1-408-745-9500
(from outside the United States).
Power supply internal devices
failure.
67 Copyright © 2018, Juniper Networks, Inc.
Chapter 5: Troubleshooting Hardware