Juniper JRR200, Hardware Manual

Page: 72 / 108

•
Retrieve the original shipping carton and packing materials. Contact your JTAC
representative if you do not have these materials, to learn about approved packing
materials. See
“Contacting Customer Support” on page 71 .
Ensure that you have the following parts and tools available:
• ESD grounding strap
•
Antistatic bag, one for each component
•
Phillips (+) screwdriver, number 2
• Packing the JRR200 Route Reflector for Shipment on page 72
• Packing the JRR200 Route Reflector Components for Shipment on page 73
Packing the JRR200 Route Reflector for Shipment
To pack the JRR200 route reflector for shipment:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
the strap to the ESD point on the chassis or to an outside ESD point if the device is
disconnected from earth ground. .
2.
On the console or other management device connected to the JRR200 route reflector,
enter CLI operational mode and issue the following command to shut down the
JRR200 route reflector software:
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
3.
Shut down power to the JRR200 route reflector by pressing the Power switch on the
rear of the route reflector.
4.
Disconnect power from the JRR200 route reflector.
5.
Remove the cables that connect to all external devices.
6.
If the JRR200 route reflector is installed in a rack, have one person support the weight
of the route reflector while another person unscrews and removes the mounting
screws.
7.
Place the JRR200 route reflector in the shipping carton.
8.
Cover the JRR200 route reflector with an ESD bag, and place the packing foam on
top of and around the device.
9.
Replace the accessory box on top of the packing foam.
Copyright © 2018, Juniper Networks, Inc. 72
JRR200 Route Reflector Hardware Guide