Juniper JATP400, Hardware Manual

Page: 40 / 113

e. Align the chassis inner rails with the ball-bearing shuttle, as shown in Figure 10 on page 33 .
Figure 10: Aligning the Chassis Rails with the Ball-Bearing Shuttle
f. Apply even pressure on both sides; slide the chassis inner rails into the middle rails until the
locking tab of the inner rail clicks into the front of the middle rail, locking the chassis into the fully
extended position.
g. Depress the locking tabs on both sides simultaneously, and slide the chassis into the rear of the
rack.
h. Use the screws to secure the chassis handles to the rack. See Figure 11 on page 33 for the
installed chassis in a four-post rack.
Figure 11: Installing the Chassis in a Four-Post Rack
33