Juniper EX3200 Series, Hardware Manual, Page: 223 / 310

CHAPTER 18
Replacing Transceiver
• Installing a Transceiver on page 201
• Removing a Transceiver on page 203
Installing a Transceiver
The transceivers for Juniper Networks devices are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the device or disrupting the device functions.
NOTE: After you insert a transceiver or after you change the media-type
configuration, wait for 6 seconds for the interface to display operational
commands.
NOTE: We recommend that you use only optical transceivers and optical
connectors purchased from Juniper Networks with your Juniper Networks
device.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
NOTE: On an EX3200 switch, if you install a transceiver in a 1-Gigabit Ethernet
uplink module port, a corresponding network port from the last four built-in
ports is disabled. For example, if you install a transceiver in the uplink module
port 3 (
ge-0/1/2
), then the built-in port 23 (
ge-0/0/22
) is disabled. The
disabled port is not listed in the output of
show interface
commands.
201 Copyright © 2016, Juniper Networks, Inc.