Jungheinrich ERE 120, Operating Instructions Manual

Page: 49 / 179

02.15 EN
48
4.2.2 Charging the battery
Starting to charge with the on-board charger
– ELH mains connection
Mains supply: 230 V / 115 V (+15/-10%)
Mains frequency: 50 Hz / 60 Hz
The mains connector of the charger (42) is integrated in the battery compartment (the
illustration shows the battery compartment of the ERE 120).
Charging the battery
Requirements
– Park the truck securely, see "Parking the truck securely" on page 65.
– Expose the battery, see "Exposing the battery" on page 43.
– Correct charging program set on charger.
Procedure
• Remove any insulating mats from the battery.
• The battery connector must remain plugged.
• Attach the mains connector to a mains socket.
• Pull the Emergency Disconnect switch up.
The flashing LED indicates the charge status or a fault (for flashing codes see “LED
Display” table).
The battery is now charged.
Z
When the mains connector is attached to the mains all the truck’s electrical
functions are disconnected (electric immobiliser). The truck cannot be operated.
Z
When the mains connector is attached to the mains the battery connector cannot
be disconnected.
42