Jungheinrich ERE 120, Operating Instructions Manual

Page: 47 / 179

02.15 EN
46
4.2 Charging the battery with an on-board charger (
o
)
DANGER!
Risk of electric shock and fire
Damaged and unsuitable cables can cause electric shocks and can overheat,
resulting in fires.
X Always use mains cables with a maximum length of 30 m.
Local regulations must be observed.
X Unwind the cable reel fully when using it.
X
Always use original manufacturer’s mains cables.
X Insulation safety, acid and caustic ratings must comply with the manufacturer's
mains lead.
X The charging connector must be dry and clean when used.
NOTE
Improper use of the on-board charger can cause material damage
The on-board charger consisting of a battery charger and battery controller must not
be opened. If faulty, contact the manufacturer’s customer service department.
X The charger must only be used for batteries supplied by Jungheinrich or other
approved batteries provided it has been adapted by the manufacturer's customer
service department.
X Batteries must never be swapped from truck to truck.
X Do not connect the battery to two chargers simultaneously.
4.2.1 Setting the charging characteristics (ELH 2415 / 2425 / 2435)
The charging characteristics (ELH 2415 / 2425 / 2435) are set via parameter 1388 of
the truck software, see "Set ELH 2415 / 2425 / 2435 Charger Characteristics with
CanCode" on page 123.
The CanCode and CanDis option is necessary to set the charging characteristics.
Otherwise, the setting may only be performed by the manufacturer's customer
service department.
Flashing sequence / charging curve assignment (ELH 2415/2425/2435)
Flashing sequence Selected charging curves (characteristics)
0 Truck without battery
o