D*AP8 MAP
72
The MAP has the action type – "Event Actions"
An action runs like a flip-book inside the MAP. This powerful technology spans from simply recalling
a certain system parameter over speaker or Dolby specific parameter combinations (household
name: "Preset") to the complete reconfiguration of the device including all signal routing, processing
parameters and so forth. It allows you to create your own snap shots where you decide what is part
of it and what is not! But it also enables several fail over scenarios where the MAP will automatically
react to the system and/or parameter status.
The steps to set up the EVENTS system are as follows:
1.
Define
- trigger sources
2.
Configure
- triggers by logical combination of the pre-defined trigger sources
3.
Set up events
- by selecting presets for function blocks
4.
Create actions
- which trigger will launch which event or what will happen in case someone presses
a function key at the X*AP RM
1
or engages the <Force Trigger Active>
check box (see EVENTS
> Actions > Event Actions).
Setup GUI – EVENTS – Triggers – Sources – Remote Hotkeys
The Triggers tab opens the trigger setup pane that has 4 embedded sub tabs:
Sources: "Remote Hotkeys" / "Network" / "Parameters" and Configuration: "Trigger Equation"
<add trigger>
You can add lines (number of entities of triggers) here.
#
The number of the Hotkey. On the X*AP RM
1
remote panel,
counting from left to right from 1 ... 8.
Label
Each Hotkey may have a label that appears in the display of the
X*AP RM
1
remote panel above that button and in the Mobile UI.
X*AP Remote
[ON / OFF]
If you turn it off the respective Hotkey on the X*AP RM
1
remote
panel becomes inactive - no label is displayed and the button
background light turns off.
Mobile
[OFF / OFF/Divider / Enabled]
The buttons of the Mobile UI can be assigned an individual color.
You will get the bright color if the button is active and the dark color
if it is inactive. [OFF/Divider] acts as a place holder for a button that
is temporarily set to OFF.
<remove>
will remove a line from the list. This will automatically disable the
respective front panel button.