D*AP8 MAP
71
Setup GUI – EVENTS - Overview
As mentioned previously, the D*AP8 MAP offers a sophisticated event management system.
The event management system performs actions. These actions are built from events.
Actions may be triggered manually (via the X*AP RM
1
remote panel Hotkeys), remotely (over the network
or via GPIs) and automatically (via changes of device parameters or internal status information)
or via a combination of all three.
The overview shows the building blocks of the EVENTS system of the MAP:
A trigger may be configured via a trigger equation (logically combined) from up to two sources. For both
sources you can define a trigger type and a specific source that is bound to the type. E.g. a GPI is a trigger
type while the hardware input (its input number) represents the trigger source. Other sources of specific
types like the X*AP RM1 Hotkeys must be configured before using it:
Remote Hotkeys
You may assign hotkeys of the X*AP RM1 remote to become a
trigger source.
Network
Received via the EmBER+ protocol designed by Co. l-s-b.
Parameters
Device parameters / status information grouped into
system and Interfaces.
The MAP offers four different event types:
Preset Events
for the System / Interfaces / Routing / Dolby Processing / Audio
Processor / Programs / AUX / Measurement
Parameter Events
to control (external) measurements of the J*AM
Measurement Events
to control the measurement block of the MAP
I/O Events
for GPOs
