D*AP8 MAP
55
Setup GUI – AUDIO PROCESSOR - Overview
The overview shows the active signal blocks of the audio processor, rendered by the DSPs.
This overview depends on the actual speaker configuration of the MAP.
Below an example for 5.1 + 2.0 (see SYSTEM > Setup > Speaker Configuration):
The processing blocks in use, which may be activated from their individual setup panes,
will be indicated in green. Blocks shown in grey are not activated by the user.
To navigate through the various processing blocks you may either use the mouse over function and
click on the respective block or use the tabs provides in the navigation bars below the bar graph
displays. The navigation is based on URLs so you may use the <Back> button of the browser to return
to this page.
Important Note! Don't be confused by the difference between speaker configuration and
the channel mode of a program. Both can be set differently and must not necessarily match.
E.g. you may configure the speaker set for 5.1 but listen to a stereo program via the left & right surround
speakers. On the other hand it makes no sense to listen to a 3/2L signal via a pair of stereo speakers
(except when you have selected the downmix ;-). You must always be careful to setup the router properly
to connect the correct audio channels with the primary or secondary input of the AUDIO PROCESOR.
Setup GUI – AUDIO PROCESSOR - Setup
Mono Attenuation
Mono Attenuation (dB) [0 / -3 / -4.5 / -6]
If a processing block is
turned into mono operation
this gain reduction will be
used.
