D*AP8 MAP
15
Setup GUI – SYSTEM – System Status
The System Status page provides a top level view of the various status information available
for the device.
Device Status
provides the hardware status of the D*AP8 unit
Power 1
status of the first power supply (left hand side from rear)
Power 2
status of second power supply (right hand side from rear)
Temperature
measured on the surface of the main PCB
Sync Lock
turns red if the external sync source is removed or unstable
Processing Status
Bypass
for the MAP is no bypass function implemented
Interface Status
display depends on the number of installed interface modules
AES I/O
turns red if an AES input that is internally in use (i.e. you have routed it to
an input of a function block) has detected an error
SDI I/O Interface
turns red if the SDI input is not locked (not present or bad SDI signal)
Analog Out Interface
turns red if the analog output card does not communicate
with the system controller
Dolby Processing Status
Decoder
turns orange if the input signal is not Dolby encoded (PCM)
Encoder A
status of the first D-E encoder (if license is installed)
Encoder B1
status of the first D-D/D-D+/AAC encoder (if optional CAT561 is installed)
status of the D-E encoder (if optional CAT569 is installed)
Encoder B2
status of the second D-D/D-D+/AAC encoder (if optional CAT561 is
installed)
Metadata
status of the metadata sub system
