Manual commissioning
On, Off
Basic setting: On
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device
cannot be reset to the factory
setting.
Local Operation
On, Off
Basic setting: On
With this device, the
parameter has no function.
6.3 Troubleshooting
After a brief button-press, the hand-held transmitter switches off.
Cause: Battery in the hand-held transmitter is almost empty.
Charge the hand-held transmitter using the USB connection.
If the problem persists: Battery is worn out. Replace it with a new battery.
Receiver does not react, status LED displays a transmission error. Status LED flashes
red quickly for 3 seconds.
Cause 1: Radio range exceeded. Structural obstacles reduce the range.
Insert a radio repeater.
Cause 2: Actuator is not ready for operation.
Check the actuator and mains voltage.
Cause 3: There are radio faults, e.g. through outside radio.
Eliminate radio interference.
i
The actuator causing the transmission error can be removed from the display of
transmission errors.
To do this, open the main menu. Select "Channels" and press
OK
.
Select the desired hand-held transmitter channel, press
OK
and then "Open".
During signalling, select "Status exclusion" and press
OK
.
The status LED lights up red. The message "Status exclusion" appears in the footer.
The actuator is automatically taken into account again when it transmits a status message
after radio transmission.
The programming mode cancels after a few seconds.
There is an eNet server in scan mode within radio range.
Terminate scan mode on the eNet server.
After a button has been pressed, the status LED flashes red quickly for 3 seconds.
Cause: Maximum permitted transmission period (statutory Duty Cycle Limit) has almost been
reached. For the function of the transmitter to continue, the polling and display of the sum status
will be switched off. As soon as sufficient transmission time is available again, the sum status
will again be polled on button actuation.
Actuate the transmitter again after a short waiting time, normally a few seconds.
Reduce the number of actuations.
Reduce the number of actuators connected to the transmitter.
6.4 Accessories
USB charger
Art. No. 521-2USB
USB power supply unit, 5 V / 500 mA
Albrecht Jung GmbH & Co. KG hereby declares that the radio system type
Art. No. FMHSD24
corresponds to the directive 2014/53/EU. You can find the full article number on the device. The
complete text of the EU Declaration of Conformity is available under the Internet address:
www.jung.de/ce
17/18
82582333
J0082582333
29.03.2017
eNet radio hand-held transmitter with display, 24-gang