A security query is displayed, asking whether the operation should be continued or not.
o
Cancel operation: Press the left menu button "No".
- or -
o
Continue operation: Press the right menu button "Yes".
The message "Reset executed" appears in the footer. All the actuator channels connected
to the selected hand-held transmitter channel are disconnected.
Connecting a scene channel with the actuator
o
Open the main menu.
o
Select "Programming" and press
OK
.
o
Select "Scenes" and press
OK
.
o
Select the desired scene and press
OK
.
o
Press "Teach scene" and
OK
.
Status LED (7) flashes red. The hand-held transmitter is in programming mode for approx.
1 minute.
o
Switch the actuator channels to programming mode (see actuator instructions).
The hand-held transmitter signals the number of actuator channels found.
o
Press the right menu button "Teach".
The status LED lights up for approx. 5 seconds. The selected hand-held transmitter
channel is connected to the actuator. The hand-held transmitter and actuator exit the
programming mode automatically.
i
If the status LED of the radio transmitter flashes 3 times at 1-second intervals for approx.
5 seconds, then the programming operation was not successful. The actuator is outside
radio range, not in programming mode or there are radio faults.
i
If the status LED of the actuator flashes 3 times at 1-second intervals for approx. 5
seconds, then the programming operation was not successful. All the memory locations in
the actuator or radio transmitter are occupied.
i
To terminate programming mode early, press the left menu button "Back".
Rename scene
o
Open the main menu.
o
Select "Programming" and press
OK
.
o
Select "Scenes" and press
OK
.
o
Select the desired scene and press
OK
.
o
Select "Rename scene" and press
OK
.
The "Edit text" window appears in the display.
o
Enter a new name (see chapter "Setting up the hand-held transmitter", "Entering texts").
o
Saving an entry: Press the right mouse-button "Save".
The message "Text stored" appears in the footer.
o
Exiting "Edit text": Press the left menu button "Back".
Removing an individual actuator channel from a scene
An individual actuator is removed from a scene by repeating the connection steps:
o
Open the main menu.
o
Select "Programming" and press
OK
.
o
Select "Scenes" and press
OK
.
o
Select the desired scene and press
OK
.
o
Press "Teach scene" and
OK
.
Status LED (7) flashes red. The hand-held transmitter is in programming mode for approx.
1 minute.
o
Switch the actuator channels to programming mode (see actuator instructions).
12/18
82582333
J0082582333
29.03.2017
eNet radio hand-held transmitter with display, 24-gang
