eNet radio transmitter modules
Degree of protection
IP20
Transmitting range in free field
typ. 100 m
Radio frequency
868.0 ... 868.6 MHz
Transmission capacity
max. 20 mW
Receiver category
2
9
Parameter list
The device parameters can be changed with the eNet Server.
Device configuration
Parameters
Setting options
Basic setting
Explanations
Function
Rocker
Other modes
Unused
Basic setting: Rocker
Rocker
The channel works as a channel button. Set-
ting is always made in pairs.
Other modes
The channel works as a scene button. Setting
is always made in pairs.
Unused
The channel is not displayed in the eNet
SMART HOME app and is disabled for use in
the commissioning interface.
Operating mode
App use, lock-out protec-
tion, forced operation, wind
alarm, sun protection, twi-
light
Basic setting: App use
Setting the type of scene used for a scene but-
ton. Setting is always made in pairs.
Advanced device settings
Parameters
Setting options
Basic setting
Explanations
Manual commis-
sioning
On, Off
Basic setting: On
Disables manual commissioning for all device
channels. Note: In the "Off" setting, the device
cannot be reset to the factory setting.
Extended channel settings
Parameters
Setting options
Basic setting
Explanations
Manual commis-
sioning
On, Off
Basic setting: On
Blocks manual commissioning for the device
channel. Note: In the "Off" setting, the device
cannot be reset to the factory setting.
Local Operation
On, Off
Basic setting: On
Blocks the device channel for local operation.
10 Troubleshooting
After a brief button actuation, the red LED flashes five times.
Cause: battery in the wall transmitter is almost empty.
Change the battery (see chapter Insert battery).
8 / 9
32579243
21.06.2019
J082579243
