eNet radio transmitter modules
Actuators switching to the saved scene.
￭
Setting a new scene.
￭
Press scene button for longer than 4 seconds.
Actuators first switching to the old scene and save the new scene after 4 seconds.
Save switch-on brightness
The buttons of a channel are set as channel buttons.
With dimmer actuators a brightness value can be saved to which the dimmer actuator switches
after a short button press.
￭
Set required switch-on brightness.
￭
Press button over entire surface for longer than 4 seconds.
The light is briefly switched off and switched on again to the switch-on brightness. Switch-
on brightness is saved.
Polling sum status
The buttons of a channel are set as channel buttons.
Polling is not possible with scene buttons.
￭
Press button over entire surface for 1 to 4 seconds.
Signalling of radio transmission and group status (see function of the status LED in opera-
tion)
6
Information for electrically skilled persons
Fitting the device
To ensure good transmission quality, keep a sufficient distance from any possible sources of in-
terference, e.g. metallic surfaces, microwave ovens, hi-fi and TV systems, ballasts or trans-
formers.
Perform commissioning procedures before installation (see chapter Commissioning).
￭
Screw or glue the base plate (1) to an even surface. The TOP/OBEN label has to be at
the top.
￭
Attach design-frame (3) to the base plate.
￭
Screw wall transmitter module (4) to base plate.
Screwing the screws too tightly could impair functions of the wall transmitter.
￭
Snap covers (6) on (Figure 1).
Information on gluing mounting
To be able to fasten the wall transmitter safely, the substrate must be flat and free of dust and
grease.
￭
Remove the rear, unpunched film of the enclosed adhesive pad.
￭
Align the adhesive pad, stick it to the surface and smooth it out. Remove air bubbles.
￭
Remove the two inner segments of the front film.
￭
Align the base plate to the external punching and stick it on.
In the case of multiple combinations, the abutting sides of the adhesive pads must be cut
along the external punching using a ruler and a cutter (Figure 3).
4 / 9
32579243
21.06.2019
J082579243
