eNet radio transmitter modules
Figure 3: Cutting the adhesive pads for multiple combinations
If necessary, after mounting the wall transmitter in the CD program, carefully remove the
excess adhesive film in the corners.
6.1 Commissioning
Insert battery
Obey the battery safety instructions.
￭
Carefully remove covers (6) from wall transmitter (Figure 1).
￭
Unscrew wall transmitter from the base plate (1)(Figure 1).
￭
Keep contacts of batteries and device free of grease.
￭
Apply battery to the positive contact of the battery holder. Observe polarity: the positive
pole of the battery must be at the top.
￭
Press gently on battery to snap it in.
￭
Mount wall transmitter onto the base plate and snap covers on.
The device is ready for operation.
DANGER!
Mortal danger of electric shock.
During commissioning, cover the parts carrying voltage on radio transmitters and ac-
tuators and in their surrounding area.
Connecting channel button to radio actuator
Up to 10 radio actuators can be connected to a transmitter in a single step.
If the programming mode cannot be activated while the cover is snapped on, the cover
must be removed.
Figure 4: Activating programming mode for channel buttons
￭
Press the top left and bottom right buttons simultaneously for longer than 4 seconds
(Figure 4).
Red LED flashes slowly. The radio sensor is in programming mode for approx. 1 minute.
￭
Switch the actuator to programming mode (see actuator instructions).
￭
Press the required channel button at the top briefly.
5 / 9
32579243
21.06.2019
J082579243
